19-84 Return to Section Topics 2600AS-901-01 Rev. B / September 2008
Section 19: Remote Commands Series 2600A System SourceMeter® Instruments Reference Manual
lan.trigger[N].stimulus
Replace N with values 1-8.
Attribute Selects which events will trigger a LAN trigger packet.
Default 0
TSP-Link
accessibility
This attribute can be accessed from a remote TSP-Link node.
Usage stimulus = lan.trigger[lanevent].stimulus -- Reads trigger identifier.
lan.trigger[lanevent].stimulus = stimulus -- Writes trigger identifier.
lanevent The LAN event number.
stimulus Identifier for the triggering event.
Remarks • Setting this attribute to zero will disable automatic trigger generation.
• If any events are detected prior to calling lan.trigger[n].connect, the event will be
ignored and the action overrun will be set.
lan.trigger[N].wait
Replace N with values 1-8.
Function Wait for LAN trigger event to be received.
TSP-Link
accessibility
This function can be accessed from a remote TSP-Link node.
Usage triggered = lan.trigger[lanevent].wait(timeout)
lanevent The LAN event number.
timeout Maximum amount of time (in seconds) to wait for
the trigger event.
triggered Trigger detected indicator.
Remarks • If one or more trigger events have been detected since the last time lan.trigger[n].wait
or lan.trigger[n].clear was called, this function will return immediately.
• After waiting for a LAN trigger event, the event detector will be automatically reset regardless of
the number of events detected.
To Next Page
Loading...
