Keithley 2600a series User Manual

19-206 Return to Section Topics 2600AS-901-01 Rev. B / September 2008
Section 19: Remote Commands Series 2600A System SourceMeter® Instruments Reference Manual
trigger.blender[N].overrun
Replace N with the values 1-4
Attribute Indicates whether an event was ignored because of the event detector state.
TSP-Link
accessibility
This attribute can be accessed from a remote TSP-Link node.
Usage overrun = trigger.blender[n].overrun
n Event blender number.
overrun Trigger overrun state.
Remarks • A read-only attribute that indicates if an event was ignored because the event detector was
already in the detected state when the event occurred.
• This is an indication of the state of the event detector built into the event blender itself.
• It does not indicate if an overrun occurred in any other part of the trigger model or in any other
trigger object that is monitoring the event. It also is not an indication of an action overrun.
trigger.blender[N].stimulus[M]
Replace N with the values 1-4
Replace M with the values 1-4
Attribute Selects which events will trigger the blender.
Default 0
TSP-Link
accessibility
This attribute can be accessed from a remote TSP-Link node.
Usage eventid = trigger.blender[n].stimulus[m] -- Reads blender trigger.
trigger.blender[n].stimulus[m] = eventid -- Writes blender trigger.
n Event blender number.
m Trigger stimulus number.
eventid Event that triggers the blender action.
Remarks • There are 4 acceptors that can each select a different event. eventid can be the event ID of
any trigger event.
• Use zero to disable the blender input.
trigger.blender[N].wait
Replace N with the values 1-4
Attribute Waits for an event blender trigger.
TSP-Link
accessibility
This attribute can be accessed from a remote TSP-Link node.
Usage triggered = trigger.blender[n].wait(timeout)
n Event blender number on which to wait.
timeout Maximum amount of time in seconds to wait for the trigger.
triggered Trigger detection indicator.
Remarks • This function will wait for a an event blender trigger.
• If one or more trigger events were generated by the blender since the last time
trigger.blender[n].wait or trigger.blender[n].clear was called, this function will
return immediately.
• After waiting for a trigger with this function, the event detector will be automatically reset and
rearmed. This is true regardless of the number of events detected.

Keithley 2600a series Specifications

General

Brand	Keithley
Model	2600a series
Category	Measuring Instruments
Language	English