Keysight E5071C ENA - Removable Hard Disk Drive Replacement (Obsolete); Tools Required; Removal Procedure

206 Keysight E5071C ENA Network Analyzers
Replacement Procedure
Removable Hard Disk Drive Replacement (Obsolete)
6-
Removable Hard Disk Drive Replacement (Obsolete)
Tools Required
• TORX screwdriver, T10
• Torque screwdriver, TORX T10 (set to 0.29 N-m / 2.6 lb-in)
Removal procedure
Refer to Figure 6-4 for this procedure.
Step 1. Insert the key (P/N 0960-2562) in the lock and turn clockwise (item 1).
Step 2. Press the button under the lock (item 2) and remove the hard disk (item 3).
Step 3. Remove the four TORX T10 screws (item 4), and remove the removable hard
disk drive’s lid (item 5).
Step 4. Remove the four TORX T10 screws (item 6) fastening the HDD bracket and
remove it.
Step 5. Remove the hard disk drive (item 7) from the connector board.
Figure 6-4 Removable Hard Disk Drive Removal (Obsolete)