Keysight E5071C ENA - Test Equipment (DSG) Model Number over; Receiver Compression - High Frequency; Description; Test Equipment

48 Keysight E5071C ENA Network Analyzers
Performance Test
7. RECEIVER COMPRESSION - HIGH FREQUENCY
2-
7. RECEIVER COMPRESSION - HIGH FREQUENCY
Description
This test measures the compression at the specified maximum power level for
the receivers with the use of the compression test set for high frequencies. The
test process measures two power deltas, one at the top of the receiver input
power range, and one in the middle of the input power range. The difference
between the deltas represents the compression at the top of the power range.
A negative test result indicates “compression” while a positive result indicates
amplitude “expansion.” If this test fails, there will be a note in the report stating
that the dynamic accuracy result is not valid.
Test equipment
Test Equipment (DSG)
1
1. The DSG (Device Substitution Group) is listed below the equipment description, if
applicable. These devices are required to be mapped in TME to execute a test.
DSGs require either GPIB communication or are important for dynamic measure-
ment uncertainty calculations. N/A refers to required equipment that is not mapped
as DSGs in TME.
Model Number Over 8.5
GHz
Option
2
2. Over 8.5 GHz are Options 2D5/2K5/4D5/4K5.
Up to
8.5 GHz
Option
3
3. Up to 8.5 GHz are Options
230/235/430/435/240/245/440/445/260/265/460/465/280/285/480/485.
Power Meter (Power Meter 1) N1914A X X
Power Sensor 1 (Power Sensor RF 1) E9340A (Opt H18) X
Power Sensor 3 (Power Sensor MW 1) E4413A X
Compression Test Set
(Compression Test Set 1)
Z5623A-K01 X X
3.5 mm cable (2 required) 8121-1834 X
Type-N cable (2 required) 8120-8862 X
3.5 mm (f) to 2.4 mm (f) adapter
(2 required)
11910B X X
3.5 mm (f) to 3.5 mm (f) adapter
(2 or 4 required)
4
4. Two required for 2-port E5071C; four required for 4-port E5071C.
85027-60005 X
Type-N (m) to 2.4 mm (f) adapter (N/A)
(2 required)
11903B X