Keysight E5071C ENA - 10 Mhz Oven Board (Opt. 1 E5) Replacement (A5); Tools Required; Removal Procedure; Replacement Procedure

Keysight E5071C ENA Network Analyzers 267
Replacement Procedure
10 MHz Oven Board (Opt. 1E5) Replacement (A5)
10 MHz Oven Board (Opt. 1E5) Replacement (A5)
Tools Required
• TORX screwdriver, T10, T15, and T20
Removal Procedure
Refer to Figure 6-36 for this procedure.
Step 1. Remove the outer cover as described in “Outer Cover Removal” on page 203.
Step 2. Remove the six TORX T10 screws (item 1) fastening the rear cover.
Step 3. Release the clamped cables from the clamps (item 2) on the rear cover.
Step 4. Disconnect the cables (item 3, 4) from the oven.
Step 5. Remove the three TORX T10 screws (item 5) fastening the oven.
Figure 6-36 10 MHz Oven Board Removal
Replacement Procedure
Step 1. Replace the 10 MHz oven board by inverse procedure of removal.