Keysight E5071C ENA - Required Adjustment after Replacing Assembly

58 Keysight E5071C ENA Network Analyzers
Adjustment
Required Adjustment after Replacing Assembly
3-
Required Adjustment after Replacing Assembly
After replacing the following assembly, the adjustment items described in
Table 3-1 must be required. The adjustment must be performed Keysight’s
qualified service personnel. If you need the adjustment for your E5071C, it
should be sent to the nearest Keysight Technologies service office.
Required Adjustment Item after Replacing Assembly
Table 3-1 Up to 8.5 GHz Options
Replaced Assembly Adjustment Item
Writing ID OCXO Frequency Reference AUX Input Synthesizer Gain Virtual Bridge Coefficient Source Output Power Receiver IF Range Receiver Port Characteristics Receiver Absolute Gain Receiver RF Range
Reference Oven
Board (OCXO)
√
Analog Base Module
(BAS)
√√
Synthesizer Module
for Source
(SYN-SRC)
√√
Synthesizer Module
for Local (SYN-LCL)
√√
Level Vernier Module
(VNR)
√
Receiver Module
(RCV)
√√√√√√
Hard Disk Drive
(HDD)
√
Distributor Module
(DIS)
√√√
RF Switch (T2-SW)
√√√