Keysight E5071C ENA - Test Equipment Required; Softkey Selection Procedure for Performance Test

Keysight E5071C ENA Network Analyzers 41
Performance Test
Introduction
Test Equipment Required
The required equipment for the performance test is listed on Table 1-2, Table
1-3, Table 1-4 and Table 1-5. Use only calibrated equipment when doing the
performance test.
Softkey Selection Procedure for Performance Test
For the latest ETE lists, refer to Keysight Test Management Environment
(TME) Software Portal. The complete ETE lists are available in E5071C
Calibration Application WebHelp. http://cal.software.keysight.com/
The procedure of the softkey selection depends on the firmware revision.
Note that some softkey selection procedures for your E5071C might be a
little bit different from the procedure described in this chapter.