337
Keysight E5071C
ENA Network Analyzers
Service Manual
D Power Requirement
Preparation for Power Supply
Before turning on power to the equipment, be sure to verify the following:
Power Requirements
The E5071C requires the following power source:
Verification and Connection of Power Cable
The three-wire power cable attached to the E5071C has one wire serving as a
ground. Using this power cable allows the E5071C to be grounded, thereby
protecting you against electrical shock from the power outlet.
Step 1. Confirm that the power cable is not damaged.
Step 1. Use the supplied cable to connect between the power cable receptacle on
the rear panel of the E5071C and a three-wire power outlet with the
grounding prong firmly connected in the ground slot.
Power cord list, 16000-99101 shows the power cable options.
Requirements
Voltage 100 - 240 VAC ± 10% (Vpeak >= 120 V)
Frequency
47 to 63 Hz
Maximum power consumption
350 VA
NEVER use a power cable showing any sign of damage. Faulty cables can
cause electrical shock.
Use the supplied power cable with grounding wire to securely ground the
E5071C.
To Next Page
Loading...
