116 Keysight E5071C ENA Network Analyzers
Troubleshooting
To configure the CPU Mother Board Assembly and BIOS
4-
Step 7. Verify that the amount of RAM installed is correct. Table 4-17 shows the
amount of RAM memory installed depending on the Digital Motherboard. If
the amount of RAM installed is not correct, the CPU Mother Board Assembly
is faulty.
Step 8. Click “OK” button to close the window.
Step 9. Turn the E5071C off before proceeding to the next step “To Confirm or Set the
BIOS Options”.
To Confirm or Set the BIOS Options
BIOS is the PC's built-in program describing the standard procedure of basic
inputs and outputs for the system hardware. BIOS involves the system BIOS,
start-up program and BIOS setup utility. The E5071C starts up first with the
BIOS when the power is turned on. If the Digital Motherboard is E5071-62001
(Celeron M 1.3 GHz), it is necessary to load the setup default when the board is
replaced. It is not necessary to change the BIOS settings for other Digital
Motherboard.
Table 4-17 RAM memory installed
Digital Motherboard Part
Number
Serial Number Prefix RAM installed
E5071-62001 MY461, SG461 0.99 GB
E5070-62070 MY462, SG462 1.99 GB
E5070-62090 MY463/4, SG463/4 3.42 GB
E5070-62091 MY465/6, SG465/6 8 GB
E5071-62060 MY467, SG467 8 GB
Table 4-18 BIOS Options
Digital
Motherboard
Part Number
CPU Unit Prefix
at Factory
Shipment
BIOS
Password
BIOS Setup
After Digital
Motherboard
Replacement
E5071-62001 Celeron M 1.3 GHz MY461,
SG461
e507xa Execute the load
Setup Default
according to the
following
procedure
E5070-62070 Celeron M 1.86 GHz MY462,
SG462
agt0nly Not necessary
To Next Page
Loading...
