Keysight E5071C ENA - Replacement Procedure

212 Keysight E5071C ENA Network Analyzers
Replacement Procedure
Removable Hard Disk Drive Replacement Option 017
6-
Figure 6-8 Removable Hard Disk Drive Removal Option 017
Replacement Procedure
Step 1. Replace the removable hard disk drive by inverse procedure of removal.
Step 2. Insert the hard disk into the slot.
Step 3. Turn the key to the left until it is locked, then remove the key.
Step 4. Restore backup files onto the new removable hard disk drive as described in
“Restore Backup Files onto the New Hard Disk Drive” on page 207.
Step 5. Calibrate the touch screen as described in “Calibration of the Touch Screen”
on page 208.
Fasten the TORX T10 screws (item 7) using a torque screwdriver.