Keysight E5071C ENA - Hard Disk Assembly Removal Option 019; Tools Required; Removal Procedure

Keysight E5071C ENA Network Analyzers 213
Replacement Procedure
Hard Disk Assembly Removal Option 019
Hard Disk Assembly Removal Option 019
Tools Required
• TORX screwdriver, T10, T15, and T20
•Flat edge screwdriver
Removal Procedure
Refer to Figure 6-9 for this procedure.
Step 1. Remove the outer cover as described in “Outer Cover Removal” on page 203.
Step 2. Remove the front panel as described in “Front Panel Removal” on page 204.
Step 3. Disconnect the two cables (item 1).
Step 4. Remove the four TORX T10 screws (item 2) fastening the hard disk assembly.
Step 5. Lift the hard disk assembly (item 3).
Step 6. Remove the two TORX T10 screws (item 4) fastening the bracket.
Step 7. Remove a TORX T10 screw (item 5) fastening the bracket.
Step 8. Be careful to release the hook from chassis (item 6) and lift the bracket (item
7).
Figure 6-9 Removable Hard Disk Assembly Replacement Option 019