Keysight E5071C ENA - Required Tools

Keysight E5071C ENA Network Analyzers 201
Replacement Procedure
Required Tools
Required Tools
The following tools are required for repair of E5071C.
Table 6-1 Required Tools
Assembly TORX screwdriver flat edge
screwdriver
torque
screwdriver
TORX T10
cutting
plier
hex
key
open torque wrench open
torque
driver
set
1
T8 T10 T15 T20 1.5
mm
9/16
in.
5/8
in.
5/16
in.
Outer Cover √√ √
Front Panel √√ √√
Removable Hard
Disk Assembly
Removal
√√ √√
Removable Hard
Disk Drive
Replacement
√√
Removable Hard
Disk Assembly
Removal Opt.017
√√ √√
Removable Hard
Disk Drive
Replacement
Opt.017
√√
Hard Disk
Assembly Removal
Opt.019
√√ √√
Hard Disk Drive
Replacement
Opt.019
√√
Power Supply √√ √ √
Digital Bridge √√ √
Handler I/O √√ √
USB (USBTMC)
Interface Card
√√ √
PCI DSP Card and
GPIB Card
√√ √ √
Digital
Motherboard
√√ √
Analog Base
Module
√√ √ √