Keysight E5071C ENA - Removable Hard Disk Drive Replacement Option 017; Tools Required; Removal Procedure

Keysight E5071C ENA Network Analyzers 211
Replacement Procedure
Removable Hard Disk Drive Replacement Option 017
Removable Hard Disk Drive Replacement Option 017
Tools Required
• TORX screwdriver, T10
• Torque screwdriver, TORX T10 (set to 0.50 N-m / 4.4 lb-in)
Removal procedure
Refer to Figure 6-8 for this procedure.
Step 1. Insert the key (P/N 1390-1375) in the lock and turn clockwise (item 1).
Step 2. Slacken the screw (item 2), then press the button (item 3) and remove the
hard disk (item 4).
Step 3. Remove the four TORX T10 screws (item 5), and remove the removable hard
disk drive’s lid (item 6).
Step 4. Remove the four TORX T10 screws (item 7) fastening the HDD bracket and
remove it.
Step 5. Remove the hard disk drive (item 8) from the connector board.
From the volume label CN925, user recovery function is not prepared. It is
required to inform this change to user before replacing the hard disk drive.