Keysight N9010B - Page 1016

3 Short-Range Comms & IoT Mode
3.8 SEM Measurement
n Data
For MSR, 5G NR, LTEAFDD, and LTEATDD Modes, returns outer offset results when "Non-Contiguous Meas
Region" on page 1096 is set to Outer or Outer & Inner (5GNR, LTEAFDD, LTEATDD only), and returns inner offset
results when it is set to Inner
The results are in the following order:
# Item
1 Reserved for future use, returns -999.0
2 Reserved for future use, returns -999.0
3
2k + 3, k = 0
Negative offset A
4
2k + 4, k = 0
Positive offset A
--- ---
26
2k + 4, k = 11
Positive offset L
10 Returns comma-separated scalar values (in dBm) of the absolute peak power of the segment frequencies. The
length of the result depends on the number of available offset (See "Number of Offsets" on page 1019)
For MSR, 5G NR, LTEAFDD, and LTEATDD Modes, returns outer offset results when "Non-Contiguous Meas
Region" on page 1096 is set to Outer or Outer & Inner (5GNR, LTEAFDD, LTEATDD only), and returns inner offset
results when it is set to Inner
The results are in the following order:
# Item
1 Reserved for future use, returns -999.0
2 Reserved for future use, returns -999.0
3
2k + 3, k = 0
At negative offset A
4
2k + 4, k = 0
At positive offset A
---
26
2k + 4, k = 11
At positive offset L
11 Returns comma-separated scalar values in dBc (dB if MeasType = PSD) of the peak power relative to the carrier
at the segment frequencies. The length of the result depends on the number of available offset (See "Number of
Offsets" on page 1019)
For MSR, 5G NR, LTEAFDD, and LTEATDD Modes, returns outer offset results when "Non-Contiguous Meas
Region" on page 1096 is set to Outer or Outer & Inner (5GNR, LTEAFDD, LTEATDD only), and returns inner offset
results when it is set to Inner
The results are in the following order:
1016 Short Range Comms & IoT Mode User's &Programmer's Reference