Keysight N9010B - Decode from Header; Coding Rate; Payload CRC Enable

3 Short-Range Comms & IoT Mode
3.3 LoRa (CSS) Demodulation Measurement
Decode from Header
This parameter determines if the parameters used by decoding the payload are
obtained from decoding the header. If not, the parameters are obtained from the
manual settings. This parameter is switched off and grays out when Implicit Header
is switched On.
Remote Command
[:SENSe]:LORA:DECode:FHEader[:STATe] OFF | ON | 0 | 1
[:SENSe]:LORA:DECode:FHEader[:STATe]?
Example
:LORA:DEC:FHE ON
:LORA:DEC:FHE?
Dependencies This control is switched Off and disabled when Implicit Header is On and is enabled otherwise
Couplings When Decode from Header is On and Implicit Header is Off, Coding Rate, Payload CRC Enable, and
Data Length (Byte) are disabled
When Decode from Header is Off and Implicit Header is Off, Coding Rate, Payload CRC Enable, and
Data Length (Byte) are enabled
Preset
ON
State Saved Yes
Range On|Off
Coding Rate
Sets the coding rate of the payload.
Remote Command
[:SENSe]:LORA:DECode:CRATe CR1 | CR2 | CR3 | CR4 | CR5 | CR6 | CR7
[:SENSe]:LORA:DECode:CRATe?
Example
:LORA:DEC:CRAT CR1
Dependencies The control is only enabled when:
Implicit Header is On,
Or Implicit Header and Decode from Header are both Off
Preset
CR1
State Saved Saved in instrument state
Range 4/5 | 4/6 | 4/7 | 4/8 | 4/5 LI | 4/6 LI | 4/7 LI
Payload CRC Enable
Enables the CRC of the payload.
Remote Command
[:SENSe]:LORA:DECode:CRC[:STATe] OFF | ON | 0 | 1
410 Short Range Comms & IoT Mode User's &Programmer's Reference