Keysight N9010B - 6.3.4 I Ext Gain

6 Input/Output
6.3 External Gain
Example Set the Ext Gain value to -10dB, and subsequently querying :LOSS will give 10 dB:
:CORR:BTS:LOSS 10
Set the Ext Gain value to 10dB. Subsequently querying :LOSS will return -10 dB:
:CORR:BTS:LOSS -10
Notes A positive value of <rel_ampl> in the above command means a loss and a negative value indicates a
gain
If :LOSS is set, :GAIN is set to the negative value of the parameter sent
If :LOSS is queried, it returns the negative of :GAIN
Preset Unaffected by Preset, but set to 0dB by Restore Input/Output Defaults or Restore System Defaults-
>All
Min/Max –/+100dB
Backwards
Compatibility
SCPI
[:SENSe]:CORRection:BTS[:RF]:LOSS <rel_ampl>
[:SENSe]:CORRection:BTS[:RF]:LOSS?
6.3.4 I Ext Gain
Affects the I channel input. However, when Q Gain in I+jQ is set to Same as I Gain,
this value is applied to both I and Q channel inputs.
Remote Command
[:SENSe]:CORRection:IQ:I:GAIN <rel_ampl>
[:SENSe]:CORRection:IQ:I:GAIN?
Example Set the I Ext Gain to 10 dB:
:CORR:IQ:I:GAIN 10
Set the I Ext Gain to -10 dB (that is, a loss of 10 dB):
:CORR:IQ:I:GAIN -10
Dependencies Not available unless option BBA is installed
Grayed-out when I/Q Path is Q Only
Preset 0 dB
Unaffected by Preset, but set to 0dB by Restore Input/Output Defaults or Restore System Defaults-
>All
State Saved Yes
Min/Max –/+100dB
Annotation Ext Gain: <I Ext Gain> dB
No annotation is shown when Input is not I/Q. Also not shown when I Ext Gain is 0.00 dB. I Ext Gain is
not shown for Input Path Q Only. When the Input Path is Independent I and Q and I Ext Gain is not the
same as Q Ext Gain, both are shown. "Ext Gain: <I Ext Gain> dB, <Q Ext Gain> dB"
2099 Short Range Comms & IoT Mode User's &Programmer's Reference