3 Short-Range Comms & IoT Mode
3.2 Modulation Analysis Measurement
Peak Search
Pressing the Peak Search control moves the selected marker to the trace point
which has the maximum y-axis value for that trace.
NOTE
Pressing the Peak Search hardkey automatically moves you to the Peak Search
page of the Marker menu AND performs a Peak Search.
Remote Command
:CALCulate:EVM:MARKer[1]|2|...|12:MAXimum
Example
:CALC:EVM:MARK2:MAX
Notes Sending this command selects the subopcoded marker
Next Peak
This control enables you to move the selected marker to the peak that is next lower
in amplitude than the current marker’s value. Only peaks that meet all enabled peak
criteria are considered. If there is no valid peak lower than the current marker
position, a “No peak found” message is generated and the marker is not moved.
If the selected marker was off, then it is turned on as a normal marker and a peak
search is performed.
Remote Command
:CALCulate:EVM:MARKer[1]|2|...|12:MAXimum:NEXT
Example
:CALC:EVM:MARK2:MAX:NEXT
Notes Sending this command selects the subopcoded marker
State Saved Not part of saved state
Next Pk Right
This control enables you to move the selected marker to the nearest peak right of
the current marker that meets all enabled peak criteria. If there is no valid peak to
the right of the current marker position, a “No peak found” message is generated
and the marker is not moved.
If the selected marker was off, then it is turned on as a normal marker and a peak
search is performed.
Remote Command
:CALCulate:EVM:MARKer[1]|2|...|12:MAXimum:RIGHt
Example
:CALC:EVM:MARK2:MAX:RIGH
Notes Sending this command selects the subopcoded marker
State Saved Not part of saved state
Short Range Comms & IoT Mode User's &Programmer's Reference 261
To Next Page
Loading...
