7 Save/Recall/Print
7.4 Print
7.4 Print
Opens a dialog for configuring printing (to the printer of your choice).
The :HCOPy command is equivalent to pressing the PRINT key.
Remote Command
:HCOPy[:IMMediate]
:HCOPy:ABORt can be used to abort a print that is already in progress. Sending
:HCOPy:ABORt causes the instrument to stop sending data to the printer, although
the printer may continue or even complete the print, depending on how much data
was sent to the printer before you sent the :ABORt command.
Remote Command
:HCOPy:ABORt
Short Range Comms & IoT Mode User's &Programmer's Reference 2311
To Next Page
Loading...
Need help?
General
