Keysight N9010B - 4.6.6.8 Scheduler; Schedule Setup; Task

4 System
4.6 Alignments
4.6.6.8 Scheduler
Setting the Scheduler to ON triggers execution of the scheduled task based on the
recurrence and time set in the scheduler since the last successful of the specific
alignment. A warning condition of “RF Preselector alignment scheduler is ON”
appears when the scheduler is set to ON. OFF prevents the Scheduler from running
any scheduled task.
Remote
Command
:CALibration:RFPSelector:SCHeduler:STATe ON | OFF | 0 | 1
:CALibration:RFPSelector:SCHeduler:STATe?
Example
:CAL:RFPS:SCH:STAT OFF
Preset Unaffected by Preset, but set to ON by Restore Defaults >"Alignments" on page 1798
State Saved No
Range
OFF|ON
Schedule Setup
Lets you schedule a task to run automatically at the background based on the
recurrence and time set in the scheduler. Make sure that the instrument’s local time
is accurate, because the Scheduler relies on this information to execute the task.
This dialog contains the following controls:
–
"Task" on page 1872
–
"Date/Time" on page 1873
–
"Hour" on page 1874
–
"Minute" on page 1874
–
"Recurrence" on page 1874
–
"Number of Weeks" on page 1874
–
"Day" on page 1875
Task
There are 3 tasks that can be selected for the scheduler to run.
–
Task 1 is the 20 Hz to 30 MHz alignment
–
Task 2 is the 30 MHz to 3.6 GHz alignment
Short Range Comms & IoT Mode User's &Programmer's Reference 1872