3 Short-Range Comms & IoT Mode
3.8 SEM Measurement
OQPSK 780 MHz | 802.15.4 OQPSK 915 MHz | 802.15.4 OQPSK 868 MHz | Z-Wave R1 (9.6 kbps) FSK |
Z-Wave R2 (40 kbps) FSK | Z-Wave R3 (100kbps) GFSK | LoRa CSS 7.815 kHz| LoRa CSS 10.4167 kHz|
LoRa CSS 15.625 kHz| LoRa CSS 20.8333 kHz| LoRa CSS 31.25 kHz| LoRa CSS 41.667 kHz| LoRa CSS
62.5 kHz| LoRa CSS 125 kHz| LoRa CSS 203.125 kHz| LoRa CSS 250 kHz| LoRa CSS 406.25 kHz| LoRa
CSS 500 kHz| LoRa CSS 812.5 kHz| LoRa CSS 1625 kHz | HRP UWB 499.2 MHz
Before XA25, there were three power measurements included in this mode: CHP,
ACP, and SEM. As of XA25, five new power measurements: CCDF, IQ Waveform,
OBW, Monitor Spectrum and Spurious Emissions have been supported by this
application, with the following exceptions:
–
For Spurious Emissions, there isn’t any customized setting for any radio
standard;
–
SEM is only supported by ZigBee;
–
LoRa’s preset isn’t supported by SEM and ACP;
The major changes of the settings of the power measurements which are impacted
by preset to standard are listed in the table below.
Short Range Comms & IoT Mode User's &Programmer's Reference 1179
To Next Page
Loading...
