Chapter 2: Front panel programming
P/N 3102352-EN • REV 005 • ISS 28DEC18 101
To program CMS devices:
1. Display the panel configuration options menu. See “Panel programming” on page 95.
2. Choose CMS Device.
3. Choose the device you want to program.
4. Program each device and option using Table 34 on page 99. For dialer options, see
Table 35 below.
5. After programming each device option, choose Save.
6. Press the Menu button to exit menu mode, or continue programming.
Dialer programming
The dialer has a number of options that you can program. Use the dialer to send event
information to the central monitoring station. You can also use it as a modem for dial-in
programming and status and report retrieval. To program the dialer (DACT), you must install
and enable the SA-DACT.
Table 35: Dialer programming options
Description
Set the dialer type to one of the following values.
Dual line: Uses LINE 1 and LINE 2 to transmit events to the central station
receiver and performs modem functions. In this mode, the dialer supervises
and reports faults on both lines.
Single line: Uses LINE 1 only to transmit events to the central station receiver
and performs modem functions. In this mode, the dialer supervises and
reports faults only on LINE 1.
Modem only: Dialer provides interface for outbound communications and the
ability for dial-in programming and status and report retrieval. If Modem Only
is selected, only Rings to Answer, Ring Type, and Callback Number can be
programmed. No other dialer options are displayed in the menu. The modem
function only works with LINE 1. In this mode, neither line is supervised.
None: No dialer is installed or if a dialer is installed, disables the dialer.
nt ID
Program account 1 options, and then program account 2 options. When you
have finished programming each account, choose Save.
Enter account 1 and 2’s four-digit ID code. FFFF is not valid.
Enter the primary receiver’s phone number. This can contain up to 20 digits
(0-9, *, #, and ,). The comma causes a two-second delay in dialing. The
number or hash symbol (#) and the asterisk symbol (*) are used with calling
feature codes and services. Consult your telephone service provider.
Enter the secondary receiver’s phone number. This can contain up to 20
digits (0-9, *, #, and ,). The comma causes a two-
second delay in dialing. The
number or hash symbol (#) and the asterisk symbol (*) are used with calling
feature codes and services. Consult your telephone service provider.
To Next Page
Loading...
