Kidde FX-64

Chapter 3: System operation
P/N 3102352-EN • REV 005 • ISS 28DEC18 139
ID
Event description
069
Self test fault: A fault was detected
while testing the panel’s internal
subsystems (memory, flash, code,
etc.)
070
Internal fault: The control panel
detected an internal hardware or
software error
071
Dialer dsbl/rem disc: The dialer was
disabled by the Remote Disconnect
button
072
Dialer line 1 fault: A ground fault or
line fault was detected on line 1 of
the dialer
073
Dialer line 2 fault: A ground fault or
line fault was detected on line 2 of
the dialer
074
Dialer delivery fail: The dialer failed
to deliver a message to the receiver
or CMS
075
Dialer normal test: A dialer test was
conducted when the panel was in a
normal state
076
Dialer abnormal test: A dialer test
was conducted when the panel was
in an off-normal state
077
Dialer configuration: The dialer is not
programmed or has unverified
changes
078
Net Comm Fault 01:
Communications between the panel
and network receiver 01 failed
079
Net Comm Fault 02:
Communications between the panel
and network receiver 02 failed
080
Net Comm Fault 03:
Communications between the panel
and network receiver 03 failed
081
Net Comm Fault 04:
Communications between the panel
and network receiver 04 failed
082
Net Comm Fault 05:
Communications between the panel
and network receiver 05 failed
ID
Event description
083
Net Comm Fault 06:
Communications between the panel
and network receiver 06 failed
084
Net Comm Fault 07:
Communications between the panel
and network receiver 07 failed
085
Net Comm Fault 08:
Communications between the panel
and network receiver 08 failed
086
Net Conf Fault 01: The panel failed
to communicate with the network
receiver 01 after a configuration
change
087
Net Conf Fault 02: The panel failed
to communicate with the network
receiver 02 after a configuration
change
088
Net Conf Fault 03: The panel failed
to communicate with network
receiver 03 after a configuration
change
089
Net Conf Fault 04: The panel failed
to communicate with network
receiver 04 after a configuration
change
090
Net Conf Fault 05: The panel failed
to communicate with network
receiver 05 after a configuration
change
091
Net Conf Fault 06: The panel failed
to communicate with network
receiver 06 after a configuration
change
092
Net Conf Fault 07: The panel failed
to communicate with network
receiver 07 after a configuration
change
093
Net Conf Fault 08: The panel failed
to communicate with network
receiver 08 after a configuration
change
094
IPGateway Trouble: IP Gateway
configuration is invalid