Kinco JD Series - Chapter 2 Precautions and Installation Requirements; 2.1 Precautions; 2.2 Environmental Conditions

10
Kinco JD Series Servo User Manual
Chapter 2 Precautions and Installation
Requirements
2.1 Precautions
1.Tightly fasten the screws that fix the motor;
2.Make sure to tightly fasten all fixed points when fixing the driver;
3.Do not tighten the cables between the driver and the motor/encoder;
4.Use a coupling shaft or expansion sleeve to ensure that both the motor shaft and equipment shaft are
properly centered;
5.Do not mix conductive materials (such as screws and metal filings) or combustible materials (such as
oil) into the servo driver;
6.Avoid the servo driver and servo motor from dropping or striking because they are precision
equipment;
For safety, do not use any damaged servo driver or any driver with damaged parts.
2.2 Environmental Conditions
Table 2-1 Environmental conditions
Environment
Condition
Temperature
Operating temperature: 0C - 40C (ice free)
Storage temperature: - 10C - 70C (ice free)
Humidity
Operating humidity: below 90% PH (non-condensing)
Storage humidity: below 90% PH (non-condensing)
Air
Indoor (No direct sunlight), no corrosive gas or combustible gas
No oil vapor or dust
Height
Below 1000 m above the sea level
Vibration
5.9 m/s2
2.3 Mounting Direction & Spacing
Please install the servo driver correctly according to following figure,or it will cause faults.
The servo driver should be vertically installed on wall.Take fully into account heat dissipation when using
any heating components (such as braking resistors) so that the servo driver is not affected.