Kinco JD Series Servo User Manual
Chapter 4 Digital Operation Panel
4.1 Introduction
A digital operation panel functions to set user parameters in a servo driver, execute instructions, or
display parameters. Table 4-1 describes all display contents and functions of the digital operation panel.
Table 4-1 Display contents and functions of a digital operation panel
Indicates whether data is positive or negative. If it is on, it indicates negative; otherwise it
indicates positive.
Distinguishes the current object group and the address data in this object group during
parameter settings.
Indicates the higher 16 bits of the current 32-bit data when internal 32-bit data is displayed
in real time.
Indicates the earliest error when history records of errors (F007) are displayed.
Indicates a data display format when parameters are displayed and adjusted in real time.
If it is on, it indicates the data is displayed in hexadecimal; otherwise it indicates the data
is displayed in decimal.
Indicates the latest error when the history records of errors (F007) are displayed.
If it is on, it indicates that internal data is currently displayed.
If it flickers, it indicates that the power part of the driver is in the working status.
Switches basic menus.
During the adjustment of parameters, short presses the key to move the bit to be
adjusted, and long presses the key to return to the previous state.
Presses ▲ to increase set values; long presses ▲ to increase numbers promptly.
Presses ▼ to decrease set values; long presses ▼ to decrease numbers promptly.
Enters the selected menu by pressing this key.
Keeps current parameters in the enabled status.
Confirms input parameters after parameters are set.
Long presses this key to switch to higher/lower 16 bits when internal 32-bit data is
displayed in real time.
Activates position positive limit signals.
Activates position negative limit signals.
To Next Page
Loading...
