Kinco JD Series - Procedure for Motor Configuration

Kinco JD 伺服系列使用手册
45
Kinco JD Series Servo User Manual
6.1.2 Procedure for Motor configuration
If there is no motor type set in driver,then the driver will appear error FFF.F or 800.0.There are two way
to set the motor type in driver as follows:
1.Panel operation.
E1
314.5
SME60S-0040-30A■K-3LK□
E2
324.5
SME80S-0075-30A■K-3LK□
S0
305.3
130D-0105-20AAK-2LS
√
S1
315.3
130D-0157-20AAK-2LS
√
S2
325.3
130D-0157-15AAK-2LS
√
S3
335.3
130D-0200-20AAK-2HS
√
S4
345.3
130D-0235-15AAK-2HS
√
F8
384.6
85S-0045-05AAK-FLFN
85S-0045-05AAK-FLFO-KT
Note： ■=A: No brake □= H：Direct cable connector √：Recommended
Configuration
=B: With brake =N：HFO series standard connector of Servo and Motor
= C：YL22 series standard connector
= M：2*M17 series Intercontec connector
= D ： M17+M23 (Power M23 Intercontec connector, Encoder M17 Intercontec
connector)