Kinco JD Series - Parameter List: Group F005 (to Set Driver Parameters)

Kinco JD 伺服系列使用手册
58
Kinco JD Series Servo User Manual
Parameter List: Group F005 (To Set Driver Parameters)
Numeric
Display
Internal
Address
Variable Name
Meaning
Default
Value
d5.00
2FF00108
Store_Loop_Data
1: Stores all control parameters
except motor parameters
10: Initializes all control parameters
except motor parameters
0
d5.01
100B0008
ID_Com
Station No. of Drivers
Note: To change this parameter, you
need to save it with the address
“d5.00”, and restart it later.
1
d5.02
2FE00010
RS232_Bandrate
Set the baud rate of RS232 port
540 19200
270 38400
90 115200
Note: To change this parameter, you
need to save it with the address
“d5.00”, and restarts it later.
270
d5.03
2FE10010
U2BRG
Sets the baud rate of RS232 port
540 19200
270 38400
90 115200
You need not restart it,but it can’t be
saved.
270
d5.04
60F70110
Chop_Resistor
Indicates the values of braking
resistors
0
d5.05
60F70210
Chop_Power_Rated
Indicates the nominal power of a
braking resistor
0
d5.06
60F70310
Chop_Filter
Indicates the time constant of a
braking resistor
Time: N*256/1000 Unit: S
60
d5.07
25010110
ADC_Shift_U
Indicates data configuration of U
phase shift.
Note:Factory parameters
/
d5.08
25010210
ADC_Shift_V
Indicates data configuration of V
phase shift
Note:Factory parameters
/
d5.09
30000110
Voltage_200
ADC original data when DC bus
voltage is 200 V
Note:Factory parameters
/
d5.10
30000210
Voltage_360
ADC original data when DC bus
voltage is 360 V
Note:Factory parameters
/
d5.11
60F60610
Comm_Shift_UVW
Indicates the excitation pointer of a
motor
Note:Factory parameters
/
d5.12
26000010
Error_Mask
Indicates error masks
Note:Factory parameters
FFF.F
d5.13
60F70510
RELAY_Time
Indicates the relay operating time of
capacitor short-circuits
Unit: mS
Note:Factory parameters
150
d5.14
2FF00408
Key_Address_F001
Sets numeric display data
/
d5.15
65100B08
RS232_Loop_Enabl
e
0：1 to 1
1：1 to N
0