More details please refer to “Mode and Control” and “Target Object” in Appendix.
Warning: Before locking the motor shaft, pay attention to the drive. Because it has constant torque output,
the motor velocity is only restricted by the value of target torque. Make sure the load is correctly installed and
in normal operation before any operation. Remember to set the maximum velocity.
8.5 Homing mode（Mode 6）
To make a system execute positioning in accordance with its absolute positioning, the first step is to define
the origin. For instance, as shown in the following XY plane, to navigate to (X, Y) = (100mm, 200mm), you
must define the origin of the machine firstly. It’s necessary to define the origin.
In mode 6, the following objects have to be defined:
To Next Page
Loading...
