Kinco JD Series - ECAN Setting（Canopen PDO Setting

Kinco JD 伺服系列使用手册
35
Kinco JD Series Servo User Manual
Example 5-4：Use JD-PC to set an User Password
Step 1:Set the number “1234”as password in the object “User_Secret” as shown in the red
box in the figure above.
Step 2:Click “Save all control parameters” in Driver->Initialize/Save to save parameters,then
Click “Reboot driver”.
Step 3:The password will be activated after rebooting driver.Then users can not set any parameters before
entering the correct password in the object “User_Secret”in “Driver Config”.
Step 4:Enter 0 in the object “User_Secret” to cancel the password after entering correct password.
5.4.7 ECAN Setting（CANopen PDO Setting）
This menu is used to set CANopen communication parameters.About details please refer to chapter 10.