Chapter 5 JD-PC Software Introductions
5.1 Software Installation
This software doesn’t need to install.Users can download JD-PC software from our website:
www.kinco.cn.
5.2 Quick Start
5.2.1 Hardware Configuration for Running JD-PC
JD-PC software can be used to configure all the parameters of JD Series servo driver via
RS232 or CANopen port.Please refer to Chapter 3 to connect servo driver and motor before using
it.
● System configuration for programming via RS232.
JD series servo driver such as JD430.
24VDC power supply for driver.
Serial programming cable,whose wiring diagram is as following figure.
PC JD Servo RS232 Interface(X3)
RxD 2 ---------------------------------- TXD 2
TxD 3 ---------------------------------- RXD 3
GND 5 ---------------------------------- GND 5
● System configuration for programming via CANopen.
JD series servo driver such as JD430.
24VDC power supply for driver.
PEAK series USB or LPT adapter from PEAK company.
CANopen communication cable,its wiring diagram is as following figure:
Pecan JD Servo CAN Interface(X4)
CAN_L 2 ---------------------------------- CAN_L 2
CAN_H 7 ---------------------------------- CAN_H 7
5.2.2 JD-PC Software Online
1.Open the folder of JD-PC and double click the icon ,then it will open the window as following figure:
To Next Page
Loading...
