Kinco JD Series - Page 21

21
Kinco JD Series Servo User Manual
Pn.L
Activates position positive/negative limit signals.
Overall
Flicking
Indicates that an error occurs on the driver, and is in the alarm state.
If the parameter adjusting display mode is featured by the decimal system:
When the units place is flickering, press ▲ to add 1 to the current value; press ▼ to deduct 1 from the
current value. When the tens place is flickering, press ▲ to add 10 to the current value; press ▼ to
deduct 10 from the current value. When the hundreds place is flickering, press ▲ to add 100 to the
current value; press ▼ to deduct 100 from the current value. When the thousands place is flickering,
press ▲ to add 1000 to the current value; press ▼ to deduct 1000 from the current value.
If the parameter adjusting display mode is featured by the hexadecimal system:
When the units place is flickering, press ▲ to add 1 to the current value; press ▼ to deduct 1 from the
current value. When the tens place is flickering, press ▲ to add 0X10 to the current value; press ▼ to
deduct 0X10 from the current value. When the hundreds place is flickering, press ▲ to add 0X100 to the
current value; press ▼ to deduct 0X100 from the current value. When the thousands place is flickering,
press ▲ to add 0X1000 to the current value; press ▼ to deduct 0X1000 from the current value.
When adjusting decimal parameters, the display mode is automatically switched to the hexadecimal
system if the data is greater than 9999 or less than -9999. In this case, the 3
rd
decimal point from left to
right is highlighted.