Korg Krome - Creating Songs (Sequencer Mode); Sequencer Overview

Detailed Editing with Combinations Layers, Splits, and Velocity Switches
49
Creating Key Splits and Layers
Splits and Layers
Let’screateaCombinationthatcombinesbothsplits
andlayers,likethediagrambelow:
1. AccesstheCombiP0:Play–ProgramT01–08page.
2. SelectapianosoundforTimbre1,abrasssound
forTimbre2,andastringssoundforTimbre3.
3. AccesstheP3:TimbreParameters–MIDIT01–08
page.
4. ForTimbres1–3,setStatu
stoINTandMIDI
ChanneltoGch(theGlobalChannel).
5. AccesstheP4:Zone/Delay–KeyZT01–08page.
6.
SetTimbre1’sTopKeytoG9,anditsBottomKey
toC4.
Youcanalsoenteranotevaluebyselectingthe
parameterandthenplayingthedesirednoteonthe
keyboardwhileho
ldingdowntheENTERbutton.
7. SetTimbres2and3
toaTopKeyofB3,anda
BottomKeyofC–1.
Key Zone Slope
Inadditionto“hard”splits,wherethesoundchanges
abruptly,youcanusetheSlopeparametersto
graduallyfadeasoundinoroutoverarangeofkeys.
Intheexampleabove,youcouldsettheBottomKeyof
timbre1toG3,andsettheTopKeyoftimbre2toG4,
sothatthesetwotimbresoverlap.
Next,ifyousettheBottomSlop
eoftimbre1to12,and
settheTopSlopeoftimbre2to12,thesoundwill
changegraduallyinsteadofchangingsuddenly.
Creating Velocity Switches
Next,let’screateasimplevelocityswitched
Combination,likethediagrambelow:
1. AccesstheCombiP0:Play–ProgramT01–08page.
2. SelectabrasssoundforTimbre1,andastrings
soundforTimbre2.
3. AccesstheP3:TimbreParameters–MIDIT01–08
page.
4. ForTimbres1and2,setStatustoINTandMIDI
ChanneltoGc
h(theGlobalChannel).
5. AccesstheP4:Zone/Delay–Vel ZT01–08page.
6. SetTimbre1’sTopVelocityto127,anditsBottom
Velocityto64.
Youcanalsoenteravelocityvaluebyselectingthe
parameterandthenplayinganotewiththedesired
velocityonthekeyboardwhileholdingdownthe
ENTERbutton.
7. SetTimbre2toaTopVelocityof63,andaBottom
Velocityof1.
Velocity Zone Slope
SimilartoKeyZoneSlopes,asdescribedabove,these
letyoufadeinandfadeoutsoundsgraduallyovera
velocityrange,insteadofasimplehardswitch.
Inthecaseoftheexampleabove,youcouldsetthe
velocityzonesofthetwoTimbressothattheypartially
overlap.Then,settheTopSlopeandBottomSlopeso
thatthesoundchangesgradual
ly,insteadofchanging
suddenlybetweenvelocityvaluesof63and64.
C–1 C4 G9B3
PianoTimbre 1
Brass
Timbre 2
Strings
Timbre 3
127
64
63
1
Strings
Velocity
switch
Timbre 1
Timbre 2
Brass