Korg Krome

Using the arpeggiator while you play Arpeggiator settings in Combination and Sequencer modes
89
Arpeggiator-A, Arpeggiator-B
ForeacharpeggiatorAandB,youcanadjustsettings
forPattern(Select),Resolution,Octave,Sort,Latch,
KeySync,andKeyboard(seepage 86).
Checking the structure of a user arpeggio
pattern
Let’sseehowthecombination“A005:BoomPowPad”
(category:LeadSplits)isconstructed.
•Selectcombination“A005:BoomPowPad”
(category:LeadSplits),andlookattheArpeggio
PlayApageandArpeggioPlayBpage.
•In“TimbreAssign”you’llseethatarpeggiatorAis
assignedtotimbres1–5,andarpeggiatorBis
assignedtotimbres6and7.
Whenyouplaythekeyboard,thedrumprogramsof
timbres1–4willbesoundedbythearpeggiopatt
ern
ofarpeggiatorA.(Timbre5isadummyprogram
usedtoplaytimbres1–4.Seepage 91.)
ArpeggiatorBwillsoundtheprogramsoftimbres6
and7.
•IfyouuncheckArpeggiatorRunAorArpeggiator
RunB,itwillstop.
Ifyoucheckitonceagainandplaythekeyboard
,
thatarpeggiatorwillbeginrunning.
•WhenyouaccesstheCombiP7:ARP/DT–ARP
ScanZonepage,you’llseethattheB“TopKey”
and“BottomKey”parametersaresetsothat
arpeggiatorBwillrunonlyforthenotesB3and
below.ArpeggiatorAissettorunforanykey.
•Thedrumprogramsoftimbres1–4usethesame
arpeggiatorApattern,butsincethenotessounded
byeachtimbrearedividedbykeyzone,eachwill
playonlyaportionofthearpeggiatorpattern.Goto
theP0:Play–ProgramT01–08pageandtrymuting
eachtimbre1–4toheartheresult.Yo
ucanadd
varietybyusingdifferentcombinationsoftimbres.
Arpeggiator settings in
Combination and Sequencer
modes
InCombinationandSequencermodes,youcanuseuse
twoarpeggiopatternssimultaneously,thankstothe
KROME’sdualarpeggiatorfunctionality.Thesettings
ineachofthesemodesareadjustedinasimilarway.
Thefollowingexampleshowshowtoadjustsettingsin
Combinationmode.
Thedualarpeggiatorfunction alityletsyoudothe
followingthings.
•Assignanarpeggiatorforeachtimbre.Choosefrom
Off,(arpeggiator)A,or(arpeggiator)B.☞step5
• IndependentlyspecifywhetherAandBwill
function.☞step6
•Selectanarpeggiopatternandsetparameters
independentlyforAandB.☞step7
• MakeScanZonepagesettingssothatyoucanuse
keyboardrangeorplayingvelocitytoswitch
betw
eennormalplayingandarpeggiatedplaying,
ortoswitchbetweenarpeggiatorsAandB.☞step8
• Makesettingsfortimbresthatwillbesilentwhen
thearpeggiatorisOff,andwillsoundonlywhen
thearpeggiatorisOn.☞step10