Korg Krome

Detailed Editing with Combinations Altering Programs to fit within a Combination
51
Altering Programs to fit
within a Combination
YoucanmakevariouschangestoProgramswithinthe
contextofaparticularCombinationtomakethemfit
betterwithotherPrograms,ortocreateparticular
soniceffects.Thesechangesdonotaffecttheoriginal
Programs,orhowthoseProgramssoundinother
Combinations(seepage 81oftheParameterGuide).
Timbre Parameters: OSC
Force OSC Mode
Ifyouwishtoforceapolyphonicprogramtosound
monophonically,setthiseithertoMN(Mono)orLGT
(Legato).Conversely,setthistoPolyifyouwishto
forceamonophonicprogramtoplaypolyphonically.
NormallythisshouldbesettoPRG,sothatthesound
willplayassetbytheoriginalProgram.
Fordetails,pleasesee“ForceOSCMode”onpage 82of
theParameterGuide.
OSC Select
IfthetimbreisusingaProgramwheretheOscillator
ModeisDoubleorDoubleDrums,andyouwantonly
OSC1orOSC2(notboth)tosound,setthistoOSC1
(onlyOSC1willsound)orOSC2(onlyOSC2will
sound).
Normally,thisshouldbesettoBTH(Both).
Portamento
IftheProgramusesportamento,butyou’dliketo
disablethisforthecurrentCombination,setthis
parametertoOff.
Conversely,ifyouwanttoforcetheportamentotobe
on,orjusttochangetheportamentotime,setthistoa
valueof001–127.Theportamentowillchangetouse
thenewlyspecifiedtime.
Normally,thisshouldbesettoPRG.
Timbre Parameters: Pitch
Transpose, Detune (BPM Adjust)
Theseparametersadjustthepitchofthetimbre.
•Inalayer‐typecombination,youcansettwoor
moretimbrestothesameprogram,andcreatea
richersoundbyusingTransposetoshifttheirpitch
apartbyanoctaveorbyusingDetunetocreatea
slightdifferenceinpitchbetweenthetwo.
•Insplit‐typecombinations,youcanuseT
ranspose
toshiftthepitch(insemitoneunits)ofthe
programsspecifiedforeachkeyzone.
Note: Ifyouwishtochangetheplaybackpitchofa
drumprogram,useDetune.Ifyouchangethe
Transposesetting,therelationshipbetweenthenotes
anddrumsoundswillchange.
Use Program’s Scale, Scale
Thisspecifiesthescaleforeachtimbre.
IfyoucheckUseProgram’sScale,thescalespecified
bytheprogramwillbeused.Timbreswherethis
parameterisnotcheckedwillusetheScalesetting.