Korg Krome

Drum Track function
100
Drum Track function settings
Drum Track function settings
in Program mode
Starting/stopping the drum track
1. AccesstheProgP7:ARP/DT–DrumTrackPattern
page.
2. “TriggerMode”specifieshowtheDrumTrack
patternwillbetriggered.
StartImmediately:WhenyoupresstheDRUM
TRACKbuttontoturniton,theLEDwilllightupand
theDrumTrackpatternwillstartaccordingtotheSync
setting.Itwillstopwhenyo
upresstheDRUMTRACK
buttontoturnitoff.
WaitKBDTrigger
:WhenyoupresstheDRUM
TRACKbuttontoturniton,theLEDwillblinkandthe
DrumTrackpatternwillwaittostart.Whenyouplay
thekeyboardorreceiveaMIDInote‐on,theDrum
TrackpatternwillstartaccordingtotheSyncsetting.
3.
SpecifytheSyncsetting.
Off:TheDrumTrackpatternwillnotsynchronizeto
thearpeggiatorthat’scurrentlyrunning,butwillstart
immediately.
On:TheDrumTrackpatternwillsynchronizetothe
arpeggiatorthat’scurrentlyrunning.
4. If“TriggerMode”issettoWaitKBDTrigger,
specifythe“Latch”setting.“Latch”specifies
whethertheDrumTrackpatternwillcontinue
playingevenafteryoutakeyourhandoffthe
keyboard.
Off:IftheDRUMTRACKbuttonison(theLEDwill
blink),thepatternwillstartwhenyouplaythe
keyboard(note‐on).Thepatternwillstopwhenyou
releasethekeyboard(note ‐off).
On:IftheDR
UMTRACKbuttonison(theLEDwill
blink),thepatternwillstartwhenyouplaythe
keyboard(note‐on).Thepatternwillcontinuewhen
youreleasethekeyboard(note‐off).Thepatternwill
stopwhenyouturntheDRUMTRACKbuttonoff(the
LEDwillgodark).
5. If“TriggerMode”issettoWaitKBDTr
igger,
specifytheKeyboardZoneandVelocityZone.
Thesesettingsspecifytherangeofkeysandvelocities
thatwilltriggertheDrumTrackpatternwhenyouplay
thekeyboard(orreceiveanote‐on).
Saving the on/off status
If“TriggerMode”issettoWaitKBDTrigger,thedrum
track’son/offstatuscanbesavedintheprogram.
If“TriggerMode”issettoStartImmediately,thedrum
track’son/offstatuswillalwaysbesavedas“off,”
regardlessofthestateoftheDRUMTRACKbutton.
EQ adjustments for the Drum Track
program
Youcanadjustathree‐bandEQfortheDrumTrack
program.
Ifyouturn“A u t o LoadProgramEQ”on(selected),the
three‐bandEQsettingsspecifiedfortheprogramwill
beautomaticallyloadedwhenyouswitchDrumTrack
programs.Normallyyouwillleavethisselected.
Youarefreetoadjustthethree‐bandEQsettingsthat
areloadedautomatically.Theseadjustmentsare
appliedrelativetotheoriginalsettingsoftheprogram.