Contents
6
Install the transformer ............................................................................38
Install the backup battery option ...........................................................39
Install the transition board option kit .....................................................40
Install the remote badge reader and universal relay options .................42
Step 6: Attach the plastic transformer plate .................................................43
Step 7: Install the finger scan option ............................................................44
Kronos Touch ID ...................................................................................44
Kronos Touch ID Plus ...........................................................................45
Step 8: Install the Wi-Fi option ....................................................................46
Step 9: Install the linear imager option ........................................................47
Step 10: Connect and secure the cables .......................................................48
Connect Ethernet cable ..........................................................................48
Secure the cables with the strain relief clip ...........................................51
Connect battery, transition board, and transformer cables ....................54
Step 11: Turn on the AC power to the device ..............................................55
Verify that the power is on ....................................................................56
Step 12: Close and lock the InTouch ...........................................................57
Tighten the strain relief clip ..................................................................57
Close the cover and secure the screws ..................................................57
Next steps .....................................................................................................59
Chapter 3: Install the Slim Profile InTouch
Step 1: Prepare the location .........................................................................62
Determine the power source for your site .............................................62
Mark insertion points for the base .........................................................63
Step 2: (Optional) Widen the badge reader slot ...........................................65
Step 3: Mount the base .................................................................................68
Step 4: Route the cables ...............................................................................70
Remove cable access plug .....................................................................70
Cable routing guidelines ........................................................................71
Route the Ethernet cable ........................................................................71
Route the AC wall transformer cord .....................................................72
Step 5: Install other options .........................................................................73
Step 6: Secure the cables with the strain relief clip .....................................73
Step 7: Connect power and cables to the main board ..................................77
To Next Page
Loading...