COMMON RAIL SYSTEM
07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
1-S288
2. Checking Wiring Harness
1. Disconnect the sensors and the ECU from the connector.
2. Check the continuity of the harness.
• When checking the continuity of terminals, refer to the
sensor terminal and ECU terminal layouts on the detailed
pages of the corresponding DTCs.
NEW9Y3200007CRS0376-1US0
Service
specification
Conducting
OK Replace the intake throttle assembly.
NG Replace the wiring harness (connectors).
To Next Page
Loading...
