Kubota 07-CR-E5 - Page 356

COMMON RAIL SYSTEM
07-CR-E5,07-CR-TE5,07-CR-TIE5, DM
1-S318
U0086 / 523595-2: CAN ETC5 (Neutral SW) frame error
Behaviour during malfunction:
• None
Detection item:
• CAN_ETC5 communication stopping
DTC set preconditions:
• Battery voltage is normal
• Starter Switch signal (Engine ECU: V12 terminal) is not activated
DTC set parameter:
• CAN ETC5 frame time out error
Engine warning light:
•ON
Limp home action by engine ECU (system action):
• Neutral SW = OFF [default value]
Recovery from error:
• Key switch turn OFF
9Y3200007CRS0509US0
U0087 / 523596-2: CAN TSC1 frame error
Behaviour during malfunction:
• None
Detection item:
• CAN_TSC1 communication stopping
DTC set preconditions:
• Battery voltage is normal
• Starter Switch signal (Engine ECU: V12 terminal) is not activated
DTC set parameter:
• No request to "TSC1 buffer" continues 3 times after over-ride control request (other than 0x00)
Engine warning light:
•ON
Limp home action by engine ECU (system action):
• Override control mode = Normal mode [default value]
Recovery from error:
• Diagnostic counter = zero or Key switch turn OFF
9Y3200007CRS0510US0
U0089 / 523598-2: CAN EBC1 frame error
Behaviour during malfunction:
• None
Detection item:
• CAN_EBC1 communication stopping
DTC set preconditions:
• Battery voltage is normal
• Starter Switch signal (Engine ECU: V12 terminal) is not activated
DTC set parameter:
• CAN EBC1 frame time out error
Engine warning light:
•ON
Limp home action by engine ECU (system action):
• Non shutdown [default value]
• Output limitation: Approximately 75 % of normal condition
Recovery from error:
• Diagnostic counter = zero or Key switch turn OFF
9Y3200007CRS0511US0
KiSC issued 03, 2022 A