Kyocera ECOSYS P8060cdn - Page 270

8-50
Setup and Registration (System Menu) > System Menu
Auto Panel Reset If no jobs are run for a certain period of time, automatically reset settings and return to
the default setting. Select to use Auto Panel Reset or not.
Value: Off, On
NOTE
For setting the time until the panel is automatically reset, refer to the following:
Panel Reset Timer (page 8-50)
Auto Error Clear If an error occurs during processing, processing stops to wait for the next step to be
taken by the user. In the Auto Error Clear mode, automatically clear the error after a
set amount of time elapses.
Value: Off, On
NOTE
For setting the automatic error recovery time, refer to the following:
Error Clear Timer (page 8-50)
Low Power Timer Set amount of time before entering the Low Power mode.
Value
For Europe: 1 to 120 minutes (1 minute increments)
Except for Europe: 1 to 240 minutes (1 minute increments)
Low Power Mode (page 2-34)
Panel Reset Timer If you select [ On ] for Auto Panel Reset, set the amount of time to wait before Auto Panel
Reset.
Value: 5 to 495 seconds (in 5 second increments)
NOTE
This function is displayed when [Auto Panel Reset] is set to [On].
Sleep Timer Set amount of time before entering Sleep.
Value
For Europe: 1 to 120 minutes (1 minute increments)
Except for Europe: 1 to 240 minutes (1 minute increments)
Ping Timeout Set the time until timeout occurs when [Ping] is executed in "System/Network".
Value: 1 to 30 seconds (in 1 second increments)
Error Job Skip Set whether a job for which a "Add paper in cassette #" or "Add paper in Multipurpose
tray" error occurred when the job was started is automatically skipped after a set period
of time elapses.
Value: Off, On
NOTE
• When a job is skipped, it is moved to the end of the job queue.
• If [On] is selected, set the time until the job is skipped. The setting range is 5 to 90
(5 second increments).
Error Clear Timer If you select [On] for Auto Error Clear, set the amount of time to wait before
automatically clearing errors.
Value: 5 to 495 seconds (in 5 second increments)
NOTE
This function is displayed when [Auto Error Clear] is set to [On].
Item Description