Kyocera KM-3050

2GN/2GP/2GR-1
1-5-5
(2) Detaching and refitting the MP separation, MP paper feed and MP forwarding pulleys
Follow the procedure below to replace the MP separation, MP paper feed and MP forwarding pulleys.
Procedure
Removing the MP unit
1. Remove four screws and remove the right
lower cover.
Figure 1-5-9
2. Remove two screws and two MP holder
plates.
3. Remove two pins, two screws and two con-
nectors, and then remove the MP unit.
Figure 1-5-10
Removing the MP separation pulley
4. Reverse the MP unit and remove the spring
and stop ring from the MP separation pulley
shaft and move the bushing inside.
Figure 1-5-11
Right lower cover
MP unit
Connectors
Pin
Screw
Screw
Pin
MP holder
plate
MP holder
plate
Stop ring
MP separation
pulley shaft
Spring
Bushing