System Menu
6-18 OPERATION GUIDE
Custom Paper Type
Printing onto prepunched paper, preprinted paper or letterhead in the one-sided mode and the two-sided mode
from the same paper source may cause displacement of hole positions or reverse orientations on both sides in
two-sided printing. Set Match Print Direction to match the orientation in one-sided printing and two-sided
printing.
Example: Paper is set as shown in the illustration.
NOTE: Setting of Match Print Direction will decrease the speed of one-sided printing a little.
With the setting of Match Print Direction, set the paper with the side for the first page face-down as shown in
illustration A. (If the optional finisher is installed, set the paper with the side for the first page face-down as
shown in illustration B.)
If the optional finisher is installed, the stapling mode may cause incorrect orientation of printing depending on
the stapling position
1 Display the Machine Default screen. (See How to
Display the Machine Default Screen on page 6-13.)
2 Press U or V to select Special P.type, and
then press the Enter key.
3 Press U or V to select Match Print Direction
or Fast Mode, and then press the Enter key.
4 Press the Reset key.
The message display returns to the copier basic
screen.
Setting One-sided printing Two-sided printing
Match Print
Direction
Fast Mode
To Next Page
Loading...
