Introduction 3
Figure 1-1
Monitor
NOTE: Maintenance personnel as well as in-the-field technicians who encounter any problems with
the multiplexed system should refer to the Multiplex Diagnostic Manual (part# 153143) for
troubleshooting information and guidelines.
Key Features
The AUTOMIZER™, with its advanced design, delivers a lower total vehicle weight and allows for a
higher packing capacity. This translates into greater flexibility and a lower Total Cost of Ownership
(TCO) for our customers.
Key features of the A
UTOMIZER™:
Environmental benefits
Light weight, high compaction, fast cycle times
Reliable electronic monitoring system
Strongly built automated lifting arm
Increased fuel efficiency and decreased fuel consumption
Low maintenance
Low profile
Warning
Your AUTOMIZER™ unit MUST BE COMPLETELY LUBRICATED before its first use.
Initial lubrication carried out by Labrie Enviroquip Group is sufficient for production and transport
purposes ONLY.
Important Notice about the Warranty
Do not forget to complete the Owner Registration Form and send it to Labrie Enviroquip Group.
Make sure to indicate the date the truck is placed in service (“In-Service Date”). This date will be
used to start the warranty period. Otherwise, the date of delivery from the factory will be used instead.