EasyManuals Logo

Labrie automizer Service Manual

Labrie automizer
243 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
8 Safety
Responsibilities
Safety is everybody’s responsibility. Both the employer and employees must play their part to ensure
safe working conditions in, on, and around the truck and to promote and enforce safe work practices
and procedures to prevent injuries and incidents as well as property/equipment damages.
Employer Responsibilities
It is the responsibility of the employer:
To ensure that the A
UTOMIZER™ is operated in accordance with all safety requirements and codes,
including all applicable regulations, the Occupational Safety and Health Act (
OSHA), and the
American National Standards Institute (
ANSI).
To ensure that employees are qualified for operating or maintaining the vehicle and its
equipment, and that they all take safety measures before working in, on, and around them.
To properly maintain all mobile equipment to meet all state/provincial and federal safety
standards.
To supply adequate safe vehicle/equipment instructions and training to employees before
assigning them to operate or maintain refuse vehicle/equipment.
To keep the vehicle maintained and properly adjusted to meet the manufacturer’s standards and
recommendations. For help or for more information, please contact the manufacturer or any of its
authorized representatives.
To keep records of all vehicle breakdowns and malfunctions, as well as any inspection and
maintenance.
To ensure that all failures or malfunctions that may be affecting the safe use of the vehicle are
repaired before the vehicle is put back into operation.
To meet the appropriate lighting requirements for night-shift work (if permitted).
To make sure that the backup alarm works properly when the vehicle is in reverse.
To take necessary measures when any damage or malfunction is reported by an employee.
To establish and ensure the application of a “lockout/tagout” procedure (see page 12) any time
inspection, repair or maintenance is performed on the vehicle, regardless of whether it takes place
on the road or in the garage.
Danger!
Never get in the hopper area when the engine is running.
Only authorized personnel may do so following a lockout/tagout procedure (see Locking
Out and Tagging Out the Vehicle on page 12).
Warning!
With your safety in mind, Labrie Enviroquip Group would like to remind you that ONLY
qualified personnel should service the hydraulic, electrical and pneumatic systems on
your refuse truck. They must also be knowledgeable about how to operate the truck and
installed equipment. Please read the Operator’s Manual prior to attempting any
maintenance or repair on your A
UTOMIZER™ vehicle.

Table of Contents

Other manuals for Labrie automizer

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie automizer and is the answer not in the manual?

Labrie automizer Specifications

General IconGeneral
BrandLabrie
Modelautomizer
CategoryAutomobile
LanguageEnglish

Related product manuals