Labrie automizer Service Manual

8
Troubleshooting
This chapter contains information to help you narrow
down and/or solve problems that might occur with
your A
UTOMIZER™. Procedures throughout this
chapter require that the people performing
troubleshooting tasks have basic knowledge in
electrical, hydraulic and pneumatic systems.
The employer shall ensure that maintenance
personnel is properly trained prior to starting
troubleshooting.
Before performing maintenance on a vehicle, make
sure that all safety procedures are applied. The
lockout/tagout procedure outlined on page 12 is
mandatory.
See Troubleshooting Guide on page 174 to resolve
commonly seen problems, or contact LabriePlus to
talk to one of our product specialists.
IMPORTANT: Schematics provided in this manual are for reference
only. Vehicle-specific schematics are provided in the
vehicle’s cab.
Tools
When trying to pinpoint the cause of a problem on a
vehicle, you need certain tools to test components
(pneumatic, hydraulic or electrical). You will find
below a list of the minimal tool set required to perform
troubleshooting procedures throughout this manual.
Brand names are only suggested.

Labrie automizer Specifications

General

Brand	Labrie
Model	automizer
Category	Automobile
Language	English