EasyManuals Logo

Labrie automizer Service Manual

Labrie automizer
243 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
44 General Maintenance
Figure 3-30
Left side rail
8. Reinstall both side rail shields by putting all the bolts back in place (see Figure 3-13).
9. Reinstall the hopper divider (see Figure 3-31) with an appropriate lifting device.
Figure 3-31
Hopper divider
10. Reinstall the hopper divider guard (see Figure 3-27).
11. Proceed with the reinstallation of the chute.
To perform this task, go to page 38 and use steps 1a) to 1l) in reverse order of disassembly.
12. Once finished re-assembling the removed components, lubricate and check for proper operation
of the packer and the chute.
Packer Cylinders
Packer cylinders that become defective through time need to be replaced. To do so, you first have to
access the faulty cylinder, remove it, and then properly proceed with the installation of the
replacement cylinder. These steps are explained in the following sections.

Table of Contents

Other manuals for Labrie automizer

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie automizer and is the answer not in the manual?

Labrie automizer Specifications

General IconGeneral
BrandLabrie
Modelautomizer
CategoryAutomobile
LanguageEnglish

Related product manuals