10 Safety
Do not use the body safety prop to prop a loaded body.
Only qualified personnel should service the hydraulic, electrical, and pneumatic systems of this vehicle.
They should also be knowledgeable about the operation of the vehicle.
General Precautions
Read and make sure that you fully understand this manual and all safety decals before performing
maintenance on the vehicle. Maintenance personnel must also read and understand the vehicle
Operator’s Manual. In case of doubt, ask a supervisor for clarifications.
Before every work day, inspect the body, the packing system, and any system that might
compromise public and/or operator safety.
Verify that the accelerator pedal, the steering wheel, mirrors, brakes, and turn signals are in good
working order.
When driving the vehicle, keep both hands on the steering wheel at all times.
Stop the vehicle completely and put on the parking brake before leaving the driving position.
When the vehicle is parked, the parking brake must be applied.
Vehicle operators must have a clear view of lifting arm operations at all times. To prevent injury to
nearby people, and damage to property and/or to the lifting arm itself, operators must be able to
stop arm movement at any time.
Before activating the lifting arm, operators shall make sure that people and obstructions are far
away from the vehicle.
A
UTOMIZER™ vehicles are primarily designed to be operated by only one operator. However, if
Labrie Enviroquip Group customers choose to operate the vehicle with more than one operator,
additional safety items shall be installed to protect the second operator from hazardous situations.
IMPORTANT: In such cases, Labrie Enviroquip Group must be informed of every and all units that will be operated
by more than one operator. Labrie Enviroquip Group will then determine and supply, at the
customer’s expense, the required safety items. For additional information, please contact LabriePlus
at 1-800-231-2771.
Do not operate this vehicle if there are any signs of damage or incomplete repairs.
Warning!
Prior to its first use, your AUTOMIZER™ must be completely lubricated, as shown on the Lube
Chart sticker located on the body curbside, near the hopper.
Initial lubrication carried out by Labrie Enviroquip Group is sufficient for production and
transport purposes only.
Danger!
Operators and maintenance personnel must adhere to the following precautions at all
times. Failure to do so may result in vehicle and/or property damage, personal injury, or
even death.
To Next Page
Loading...
Need help?
General
