Leica SL2 - Page 134

Picture Mode
EN
134
You can select the desired number of exposures (3 or 5). The
exposure difference, which can be set via EV StepsEV Steps, can be up to
3EV. The available values depend on the global setting EV IncrementEV Increment
(see p.79).
▸ Select Drive ModeDrive Mode in the main menu
▸ Select Exposure BracketingExposure Bracketing
▸ Select the desired number of pictures under Number of FramesNumber of Frames in
the sub menu
▸ Select the desired exposure offset under EV StepsEV Steps in the sub
menu
▸ Select the desired Exposure CompensationExposure Compensation value in the sub menu
• The marked exposure values change positions according to
the settings selected. In the case of exposure compensation,
the scale also shifts.
• The selected exposure compensation value will be applied to
the entire exposure series.
▸ Shutter release
Notes
• Appears on the LCD panel if the bracketing function is
activated. You can watch the effect of the function on screen
while the pictures are taken (brighter or darker).
• Depending on the exposure mode, the exposure gradations are
produced by changing the shutter speed and/or aperture value:
– Shutter speed (A/M)
– Aperture (S)
– Shutter speed and aperture value (P)
• The picture sequence: underexposed/correct exposure/
overexposure.
• The working range for automatic bracketing may be limited
depending on the available shutter speed/aperture combination.
• With automatic ISO sensitivity control enabled, the sensitivity
calculated by the camera automatically for the raw picture will
also be applied to all other pictures in a series, i.e. the ISO value
will not change during bracketing. This may mean that the
slowest shutter speed specified under Shutter Speed LimitShutter Speed Limit is
exceeded.
• The focus range for automatic bracketing may be limited
(depending on the originally set shutter speed). The specified
numbers of pictures will be taken regardless. Several pictures in
a series may consequently be taken with the same exposure
values.
• The function remains active until another function is selected in
the Drive ModeDrive Mode sub menu or the camera is switched off and on
again. If no other function is selected, another series of pictures
is taken each time the shutter button is pressed.