Leica SL2 - Power Save Mode (Standby Mode); Lcd Panel;Viewfinder (Evf) Settings

Camera basic settings
EN
72
POWER SAVE MODE (STANDBY MODE)
The camera will switch to the power-saving standby mode after a
preset time to extend battery life if this function is activated.
The device has two power save levels.
– Standard Save mode:
Activates device standby mode in
3s/5s/10s/2min/5min/10min
– Automatic LCD panel shutdown (see p.75)
STANDARD SAVE MODE
Factory setting: 2 min2 min
▸ Select Camera SettingsCamera Settings in the main menu
▸ Select Power SavingPower Saving
▸ Select Auto Power OffAuto Power Off
▸ Select the desired setting
(OffOff, 3 s3 s, 5 s5 s, 10 s10 s, 2 min2 min, 5 min5 min, 10 min10 min)
Note
• The camera can be woken from standby mode at any time by
pressing the shutter button or by switching the main switch off
and on again.
LCD PANEL/VIEWFINDER (EVF) SETTINGS
The camera comes equipped with a 3.2” liquid crystal color panel,
which is protected by a glass cover made of extremely hard and
scratch-resistant Gorilla
®
glass.
The following functions can be configured and used individually:
– Use of the LCD panel and EVF (electronic viewfinder)
– Eye sensor sensitivity
– Brightness
– Color rendering
– EVF Frame Rate
– Automatic LCD panel and EVF shutdown