EasyManua.ls Logo

Leica SL2 - Page 8

Leica SL2
220 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
8
CHARGER
Using the charger in the vicinity of broadcasting receivers may
interfere with reception. Ensure a distance of at least 1 m (3 ft)
between the charger and the receiver.
When the charger is in use, it may emit a buzzing sound – this is
normal and not a malfunction.
Disconnect the charger from the mains when it is not in use, as
it consumes electricity (a very small amount), even if no battery
is inserted.
Always keep the charger contacts clean, and never short circuit
them.
MEMORY CARD
Never remove the memory card during a datasave or card
reading process. The camera must not be switched off or be
subjected to impact or vibrations while working.
Do not open the cover/remove the memory card or the battery
while the status LED is lit, which indicates memory access. Data
on the card may otherwise be destroyed and camera malfunc-
tions may occur.
Do not drop or bend memory cards as this will cause damage
and result in the loss of stored data.
Do not touch the connections on the reverse of the memory
card and keep them clean and dry.
Keep memory cards out of the reach of children. Swallowing a
memory card may cause suffocation.
SENSOR
Cosmic radiation (e.g. during flights) may cause pixel defects.
CARRY STRAP
Carry straps are usually made of very robust material. You
should therefore keep it out of the reach of children. A carry
strap is not a toy and poses a strangulation risk.
Use the carry strap only for its intended purpose on a camera or
on binoculars. Any other use poses the risk of injury and may
possibly result in damage to the carry strap and is therefore not
permitted.
Carry straps should also not be used for cameras/binoculars
during sports activities that pose a risk of entanglement (e.g.
when mountain climbing and similar outdoor activities).
TRIPOD
When using a tripod, make sure it is standing securely and turn
the camera only by turning the tripod, not the actual camera.
Ensure that the tripod screw is hand-tightened only. Avoid
transporting the camera while the tripod is attached. You might
injure yourself or others and the camera could get damaged.
FLASH
The use of incompatible flash units with your LeicaSL2 may
result in irreparable damage to the camera and/or the flash unit.
Safety remarks

Table of Contents

Other manuals for Leica SL2

Related product manuals