1. Reset the average total of the wrapped bale to 0
Hold 5
sec.
3.2.3.6 RPM/min. (Screen 6)
The RPM/min. screen shows the current speed of revolution of the wrapping
table at intervals of three seconds in the range of 0...99 r.p.m.
Select the speed value
1. Activate this menu to define the speed.
Hold this button to the end of this procedure.
hold
2 Cycle through the digit code (0-9) to select the speed.
Hold the button until the correct value is shown.
hold
3. Save the speed value.
release
4. Go to the previous screen.
release
0.r
◄ ▼
3-8 Operation
W-H003.1403EN
To Next Page
Loading...
