EasyManua.ls Logo

LELY JUNO 150 - Page 110

LELY JUNO 150
126 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9-6 Troubleshooting
D-I012.1109EN
innovators in agriculture
42 CALIBR_I_PCB Calibrate voltage PCB not
good -> deviation too high!
1. Call your local Lely service
provider.
43 BATTERY_STOP Juno battery runs down.
Switch off or charge Juno
The JUNO 150 stops and beep for 1
hour.
1. Clean the charging strips and the
charging electrodes (page 7-4).
2. Manually drive the JUNO 150 to
the charging station (page 6-4).
Make sure the battery is charging
(page 8-3).
44 BATT_FATAL_ER FATAL ERROR! Battery
becomes overloaded. Remove
Juno from loader Call Lely!
1. Call your local Lely service
provider.
46 GYRO_AUTOCAL Auto calibration of the gyro is
finished.
This alarm appears with every
successful autocalibration of the
gyroscope. For information only.
47 GYRO_AUTOSTOP Auto calibration of gyroscope
is interrupted! Calibrate
gyroscope (menu Settings)
1. Calibrate the gyroscope (page
9-14).
2. If the problem remains, call your
local Lely service provider.
48 BATTERY_OFF
After 1 hour of alarm #43, the JUNO
150 will power off.
1. Clean the charging strips and the
charging electrodes (page 7-4).
2. Manually drive the JUNO 150 to
the charging station (page 6-4).
Make sure the battery is charging
(page 8-3).
49 BATTERY_CABLE Loader error! Check cable
connections
1. Call your local Lely service
provider.
50 DIRECTION_JUN Juno not in correct direction!
- obstacle
- gyro drifting
- bend in action
1. Make sure there are no obstacles.
2. Calibrate the gyroscope (page
9-14).
3. Test the ultrasonic sensor (page
8-4).
4. Start the timed actions.
5. If the problem remains:
1. Analyse the route and make
a more reliable route if
necessary (page 8-2).
6. If the problem remains, call your
local Lely service provider.
51 NOT_IND_ZERO Inductive sensors not
calibrated!!
1. Call your local Lely service
provider.
54 CLOCK ERROR The 24 hours clock is not
correct -> adjust the time!!
1. Make sure the real-time clock is
set in the correct 24 hour format
(page 8-1).
2. Make sure all start and end times
in the time path are entered in
the correct 24 hour format (page
8-1).

Table of Contents

Other manuals for LELY JUNO 150

Related product manuals